ULTRASTOR ULTRA 12F, Руководство по установке

Страница: 47 / 52

APPENDIX REFERENCE II
On the primary controller card, the following jumpers should be set as below:
JP10 - 1-2 OUT BIOS address at C800:0*
3-4 OUT
5-6 IN
JP12 - OUT Hard disk primary I/O port address (1F0-1F7, 3F6-3F7)
JP17 - IN Enable floppy controller (If system board doesn’t support
floppy circuit)
OUT If system motherboard support floppy
**JP20 - 1-2 OUT
2-3 IN IRQ14 select
On the secondary controller card, the following jumpers should be set as below:
JP10 - 1-2 OUT BIOS address at CC00:0*
3-4 IN
5-6 OUT
JP12 - IN Hard disk secondary I/O port address (170-177, 376-377)
JP17 - OUT Disable floppy controller
**JP20 - 1-2 IN IRQ15 select
2-3 OUT
* Note: The primary card BIOS address can be at D000:0 or D800:0. The
secondary card BIOS address can be at D400:0 or DC00:0. Make sure that
the primary card BIOS address is lower then the secondary card BIOS
address.
Please refer to UltraStor ULTRA 12F/12F24 or 12C Installation Guide for
additional BIOS addresses.
** Note: JP20 for 12F24, JP21 for 12C.
Reference Manual