Ultrasonic Ultra 3800FLT, Руководство по эксплуатации

Страница: 14 / 19

UltraSonic LLC. Model Ultra 3800FLT
14
NORMAL OPERATION

Make sure solution is at operating temperature.

Arrange parts in baskets & lower basket into solution.

Push green Cycle Start button.

Close lid when not loading/unloading parts.

When ultrasound turns OFF, Filtration will turn on automatically to skim off any
surface oils & contaminants into the weir tank.

Remove basket. NOTE: Parts are hot, use proper protective equipment to prevent
exposure.
MAINTENANCE

Preventative - There is a minimum of preventive maintenance required. The overall
environment around the unit needs to be kept clean, dry and dust free.

Routine - Filter Element should be replaced when the pressure gauge indicates rise in
pressure or the flow from the spray bar located in the front of the main tank is slowed.
Most users regularly replace their filter each month to avoid any decrease of flow.
Solution should be replaced regularly to avoid a drop in cleaning performance that
will result from too many contaminants in the solution.
NOTE: Canister and solution
are hot and may be contaminated; protective clothing and equipment should be used
to prevent any exposure. To change filter elements, remove solution from
front/cleaning tank until water level is below spray bar. Remove cover in back of
machine to access filter canister using a 15/16" wrench to loosen and remove canister.
Insert filter element into the canister. Carefully reattach canister to housing (be
careful not to damage O-rings), hand tighten the canister in place to ensure a tight fit,
use wrench to snug canister, do not over tighten.
NOTE: Consult your UltraSonic LLC representative for recommended schedule for
filter and solution changes based on your application.
EQUIPMENT CLEANING