Ultrasonic 2400FA, Руководство по эксплуатации

Страница: 10 / 17

UltraSonic LLC. Model Ultra 2400FA
10
Insert filter element into the canister. Carefully reattach canister to housing (be
careful not to damage O-rings), hand tighten the canister in place to ensure a tight fit,
use wrench to snug canister, do not over tighten.
NOTE: Consult your UltraSonic LLC representative for recommended schedule for
filter and solution changes based on your application.
EQUIPMENT CLEANING

Push Power OFF button (all control lights should be OFF).

DISCONNECT UNIT FROM POWER SUPPLY.

Wait a minimum of 30 minutes before draining contaminated solution from the tanks
(this enables heating element to cool and prevent damage)

Drain both tanks, NOTE: Solution is hot and may be contaminated; protective
clothing and equipment should be used to prevent any exposure.

Remove and clean filter housings located in rear tank.

Rinse the inside of the tanks with clean, clear water.

Do Not Plug in Machine until unit is full of water and cleaning solution, doing so
may cause damage to your UltraSonic tank and Void warranty

Wipe down the inside of tanks with a clean, soft cloth. Do not use any abrasive pads
or cleaners. These kinds of cleaners can scratch the tank surface and void warranty.

Wipe work and outside surfaces with a dry, clean, soft cloth.

When discarding contaminated solution and filters follow all local, state and
federal environmental and regulatory requirements.

Follow installation instructions listed earlier for refilling and start up procedures.
MAXIMIZING ULTRASONIC PERFORMANCE

Temperature - Temperature has a dramatic effect on the cleaning performance and
time needed to clean a part. The recommended temperature range is 140

F to 150

F.