ULTRA SECURE
www.ultrasecuredirect.com
29
UltraCOM 4G status information
Information about Normal and Installation modes
The UltraCOM 4G has an Installation mode and a Normal mode. The role of the
Installation mode is to provide information to easily solve technical problems that
may be encountered by the device (
network problem, SIM card problem, etc.
).
The default mode (
and after reset
) is Installation mode. After 10 minutes in Installation
mode, the panel automatically switches to Normal mode. To change the mode,
press and hold the front panel call button for 10 seconds. The device will then emit
a long confirmation beep. When restarting the panel, the current mode is retained.
Intercom status information table
The flashing of the call button on the panel will give you information on the state of
the UltraCOM 4G. Find this information in the table below.
Status
Call button flashing
Normal mode
Installation mode
Start-up
Lights up for 2 seconds
Network connection
Flashes quickly
Error: SIM card not
inserted in the panel
Flashes very quickly
Flashes 4 times, then turns off
(
loop
)
Error: SIM card cannot
connect
Flashes 3 times, then turns off
(
loop
)
Error: network quality is
insufficient
Flashes 2 times, then turns off
(
loop
)
No registered admin and
user
Blinks very slowly
(
0.5 s on / 5 s off
)
Blinks slowly (
1 s on / 2 s off
)
The panel works normally
On, steady
Off, steady
Possibility of having
a network status (
see
information table on the
network status below)
Call made
Flashes in a loop
End of call
Flashes 3 times
SMS reception
Flashes 1 time
Relay enabled
Flashes 10 times and then triggers the relay
