Ultrak KD6 Z-SERIES, Советы по установке и обслуживанию

Страница: 7 / 23

518854-2960-D 1 KDMU040013
7/20/01
1.0 DESCRIPTION
A KD6 Z-Series Dome is a pan and tilt mechanism containing a camera and lens that is controlled
remotely by an operator using a Diamond series control system. The KD6 Z-Series Dome
consists of a top dome, pan and tilt unit, and a bottom dome. The KD6 Z-Series Dome can be
mounted indoor on a ceiling pendant or wall pendant mounting bracket, in a dropped ceiling or a
hard ceiling. There is also a Weather Dome version of the KD6 Z-Series Dome for outdoor
applications. The whole assembly is often referred to as a "dome". The pan and tilt mechanism
with camera and lens is often referred to as a “yoke or "scan".
The indoor pendant top dome can be mounted on Ultrak’s indoor pendant ceiling dome mount or
indoor wall dome mount. The weather dome can be mounted on Ultrak’s outdoor wall mount.
2.0 RECOMMENDED INSTALLATION TOOLS & CABLING
Standard electrical technician tools are required for installing the KD6 Z-Series Dome.
Table 1. RECOMMENDED CABLING AND CONNECTORS
Type Recommended Cable
Ultrak
Part Number
Maximum Distance
Video Coax, RG-59/U, 75 Ohms
BNC Connector, Crimp On for RG-59/U
BNC Connector, Screw Type for RG-
59/U 849518-0054
842374-0194
842374-0391 1500 Feet (457 Meters)
Data 1 Twisted-Shielded-Pair RS-485 Cable 849518-0334 4000 Feet (1219 Meters)
Power 18 AWG 2-Conductor , Vinyl Jacket 849518-0336 See Gauge Chart for Each
Unit
3.0 EQUIPMENT HANDLING
Domes - It is extremely important to treat the surface of all domes with the same care as you
would a fine camera lens. The surface is easily scratched.
A. Always handle the dome from its outside surface.
B. Only use non-abrasive cleaners for acrylic plastic on the clear and smoked domes.
Pan and Tilt Assembly - The pan and tilt assembly consists of the pan and tilt mechanism, the
camera with zoom lens, power supply board, and digital receiver board. Do not attempt to
remove the camera from the scan assembly. If a camera or lens requires service, the entire
scan assembly must be sent back to the factory.
CAUTION
The Receiver Board and Power Supply Board On The Scan Assembly Have
Static Sensitive Devices. The KD6 Z-Series Dome Assembly Is Shipped In A
Pink Bag That Is Static Dissipating. The Unit Should Be Handled In This Bag
Until Installed. If The Unit Is Shipped, It Must Be Shipped In The Pink Bag Or
An Equivalent Static Dissipating Enclosure.
Camera Lens – Handle the camera lens with extreme care. Never touch the lens surface. Refer
to paragraph 7.0 Maintenance for cleaning the camera lens.