. Plug the connector into the auto iris jack on the top of the camera.
The connector is polarized and can only be inserted into jack one way.
. The EI switch should be in the OFF position.
. The A/I switch should be in the DC position.
. Apply power to the camera.
. Adjust the auto-iris lens for an optimum picture using the IRIS (A) control
on the top of the camera.
C
D
E
F
G
5.4
A
B
C
D
E
F
G
H
I
BACK FOCUS ADJUSTMENT
For best results, perform back focus adjustments at night or while using a #6 or
#8 welders glass in front of the lens. The focus of the camera will change
slightly if the camera iris was adjusted on a light scene, then changes to a dark
scene. However, the camera will remain in focus if the iris was focused on a
dark scene and the scene lightens.
. After mounting the lens apply power to the camera.
. If a picture is visible, focus on the scene. If the picture is not visible, open
the iris on the lens. Open the lens as wide as possible by placing the welder's
glass in front of the lens and forcing the lens to automatically open.
. When the iris is open to the widest point, readjust the focus for a clear picture.
If a clear picture is not possible, set the focus ring to midrange.
. Loosen the back focus lock screw.
. Adjust the back focus ring for a clear picture.
. Tighten the back focus lock screw.
. Fine tune the focus with the focus ring on the lens.
. Remove the welders glass from in front of the lens.
. Adjust the iris of the lens for the best picture quality.
16
