Ultrak HEB10, Руководство по установке

Страница: 7 / 20

4
2.2 HEB10-HK/HEB12-HK HEATER KIT INSTALLATION
(without blower)
This section contains instructions for installing the heater kit for
the HEB10, HEB10-01, HEB12 and HEB12-01 camera housings.
If you are also installing the blower unit, please skip to page 5 for
comprehensive instructions.
While this heater kit is sold as an add-on component for the
HEB10, HEB10-01, HEB12 and HEB12-01, it is also available in
a preassembled package. The HEB10-02 and HEB12-02 are 10-
and 12-inch camera housings respectively with an installed
sunshield and heater. The HEB10-03 and HEB12-03 add a
blower kit to this package.
1. If applicable, remove the sunshield by sliding it off the main
housing unit.
2. Loosen the two Phillips panhead screws located midway up
the rear of the housing. Leave the screws intact in the rear
portion of the housing.
(See Figure 4)
3. By sliding the housing shell away from the rear portion of the
unit, separate the housing into two sections. Be careful not to
disconnect the end of the ground cable that is attached to the
housing shell.
(See Figure 4)
4. Locate the following parts that are taped to or enclosed in the
housing: two black plastic elevation plates, a nylon washer,
and three hexagonal screws of varying lengths for camera
mounting. Set these parts aside for later use.
FIGURE 4