Ultrak HEB10, Руководство по установке

Страница: 5 / 20

2
SECTION 2
HOUSING INSTALLATION INSTRUCTIONS
2.1 HEB10-BK BLOWER KIT INSTALLATION (without heater)
This section contains comprehensive instructions for installing
the blower kit into the HEB10, HEB10-01, HEB12 and HEB12-01
camera housing. The HEB10-BK is compatible in both the
HEB10 and HEB12 series. If you are also installing the heater,
please skip to page 5 for comprehensive instructions. The blower
kit is available in a preassembled package with a housing, heater
kit, and sunshield under model HEB10-03 or HEB12-03.
1. If applicable, slide the sunshield off the main housing unit.
2. Remove the two Phillips panhead screws located midway up
the rear of the housing. Retain the screws and their black
rubber gaskets, which were left in the holes on the rear of the
housing.
(See Figure 1)
3. By sliding the housing shell away from the rear portion of the
unit, separate the housing into two sections. Be careful not to
disconnect the end of the ground cable that is attached to the
housing shell.
(See Figure 1)
4. Locate the following parts that are taped to or enclosed in the
housing: two black plastic elevation plates, a nylon washer,
and three hexagonal screws of varying lengths for camera
mounting. Set these parts aside for later use.
5. Remove the standard silver camera mounting plate by
unscrewing the two flathead screws located at the rear.
Retain the screws.
(See Figure 1)
FIGURE 1