Installation and maintenance manual
ULTRAFLEX
page 12
of 43 -
T67 STEERING SYSTEM
E
N
G
L
ISH
4
Turn the helm nut (18) to screw the cable
sheath end (17) until it touches it. Then insert the
protective tube (16) removed before (see pic. 2)
and place it on the cable coming from the helm
until the the helm tube is covered.
6
Make sure the direction of the steering wheel rotation corresponds to the boat direction
.
This control must be carried out before the boat is operated in the water.
WARNING
18
17
5
Fix the cable sheath every 2 m (6'). The sheath
must not be fixed to the electric wires.
Bulkhead openings require a minimum 38mm
(1 1/2) hole diameter.
Make sure the single cable sheath does not enter in contact with cutting edges that could damage it.
DANGER
DANGER
During the single cable assembly on the helm, prevent any dust or
foreign material from coming in contact with cable end and the helm
itself.
7
To modify the sensitivity of the steering wheel
it is possible to adjust the friction positioned on
the hub. By means of a slotted screwdriver (X),
act on the screw (7) through the mounting bezel
hole.
X
7
16
2m
2m
