13
accuracy.
■
About:
Check Firmware version, System Time, Battery power, and SD card
status.
Chapter 6 Firmware Upgrade
■
Put the upgrade file (.zip) to the root of the SD card and make sure that there is
no other zip file in the same root.
■
Insert the SD card into the camera.
■
Turn on the camera and while the SD card status is “OK”, the camera will start
to upgrade.
■
After finishing upgrading, the camera will reboot.
■
The upgrade file will be remembered so the camera will not keep upgrading by
the same file.
■
If the zip file is not recognized successfully, the camera will stop upgrading and
show “aborted” on the OLED screen. Please press power button to shut down the
camera and check the file again.
Federal Communication Commission Interference Statement
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses, and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
FCC Caution:
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
˙
Any changes or modifications not expressly approved by the party responsible for compliance could
void the authority to operate equipment.
˙
This device and its antenna must not be co-located or operating in conjunction with any other
antenna or transmitter.
˙
For product available in the USA/Canada market, only channel 1~11 can be operated. Selection of
other channels is not possible