Truck Bed or Motorcycle Lift Mounting
•
Place the Base (7) over the desired location in the truck bed or motorcycle lift. Use the Base (7) for a
pattern and mark where you the holes need to be drilled in order to mount the Wheel Chock. Use a drill
(not included) and a steel cutting bit (not included) to drill the holes in the truck bed or motorcycle lift.
•
Attach the Base (7) to the truck bed utilizing the Mounting Bolts (6), Nylon Sleeves (8), Large Washers
(9) and Spring Washers (3). Secure with Hex Nuts (10). See Diagram and Parts List.
OPERATION
WARNING:
Do not drive motorcycle into the Wheel Chock.
•
Select the correct mounting hole for the motorcycle being loaded into the Wheel Chock, and use the
Pivot Bolts (5) to secure the Pivoting Bracket in place.
•
To load a motorcycle, lower the Pivoting Bracket (13) to the horizontal position and simply push or
slowly drive the motorcycle into the Wheel Chock.
•
The Pivoting Bracket will close on the motorcycle tire, securing the bike in an upright position.
•
For long-term storage, or if the Wheel Chock is mounted to a mobile platform, the motorcycle should
be secured with belts or straps (not included).
MAINTENANCE
•
Before each use,
inspect the general condition of the Wheel Chock. Check for loose screws, poor
alignment or binding of moving parts, cracked or broken parts, and any other condition that may affect its
safe operation. Do not use damaged equipment.
•
Occasionally, wipe the Wheel Chock down with soft cloth and mild detergent.
Page of 6
4
