Ultra-tow 43195, Руководство пользователя

Страница: 4 / 7

•
Insert mounting bolt (6) on the U bracket (2) to the mounting surface (hole drilled).
Then attach the washer (7) and nut (8). Do not over tighten the screws.
INSTALL THE WIRES/SWITCH
•
Disconnect the negative termi
nal of the vehicle’s battery. (This may require
resetting your radio, clock or other electronic devices when reconnected.)
•
Find a convenient location near the bottom of dashboard to mount the switch. A
square hole (2-7/8
” x 1-7/8”) should be cut out from the board. Route the Input and
output wires through the square hole. Then squeeze the switch into the square
hole.
•
Follow the
“WIRING DIAGRAM” below,
Connect two wires to battery (white wire
to positive terminal, and black wire to the negative terminal). Connect other three
wires of the switch to light. Marked on the wires. If connect all components need
harness, ensure has 10 Amp fuse on the harness to protect the light and vehicle.
•
Reconnect the negative terminal to the battery and turn on the switch to test the
whole system. If both of the lights do not come on, inspect the system in the
following series: fuse/ ground wire/ battery connection/ switch/ lamp connection/
relay. Replace the defective parts if necessary.
•
With the system on, visually check the light beam, then turn off the switch and
adjust the lamps’ angle. Repeat this adjustment until a proper light beam appears,
then firmly tighten all screws of the light unit.
OPERATION
Connect switch to light and 9-32V power supply. There are three buttons in the
switch, which are marked
“Power,” ”Spot,” ”Flood.”
Press
“power” and “Spot”, the light delivers a spot beam.
Press
“power” and “Flood”, the light delivers a flood beam.
Press
“power”, “Spot” and “Flood”, the light delivers the spot/flood combo beam.
MAINTENANCE
•
It is recommended that the general condition of the worklight be examined before
it is used. Keep your worklight in good repair by adopting a program of
conscientious repair and maintenance. Have necessary repairs made by qualified
service personnel.
•
Clean the surface of worklight lens frequently to keep its brightness.
•
When any malfunction occurs, stop using and repair it immediately as soon as
possible. Please operate your worklight according to the proper operation
procedures.