ULTRA TEC 3250.1, Руководство пользователя

Страница: 37 / 40

- 33 -
First Operation: Determines whether the Repeat Cycle will start with an ON or an OFF Operation. (This
parameter will only appear if Repeat Cycle is chosen as the Operating Function.
Interval Time: Sets the amount of time the output will be active after the On Delay function has timed
out. Use the 1 through 4 keys to set the value in a range from 0.1 to 999.9 seconds. (This parameter will
only appear if Delay/Interval is chosen as the Operating function.)
Time Range: Sets the unit of measure for the time values that will be shown on the display in Operation
Mode. Choices are:
•
Seconds
•
Minutes
•
Hours
•
Minutes:Seconds

Factory Setting
•
Hours:Minutes
Decimal Position: Sets the decimal position for the time display. Choices are: no decimal point (0),
1/10ths position (0.0), or hundredths position (0.00). The time range selected in the previous parameter
will remain illuminated for reference. (This parameter will not appear if Minutes:Seconds or
Hours:Minutes is selected as the time range.)
Timing Direction: Determines whether the time value will increment from zero and change the state of
the output at the set value (uP) or decrement from the set value and change the state of the output at zero
(dn).
Power Reset Enable: After a loss of power the unit can be programmed to either reset upon reapplication
of power (On)

Factory Setting , or continues from the point of power interruption (Off).