SYSTEM PROGRAMMING -
Menu 1
PAGE 2
80 SERIES
INSTALL MANUAL
TABLE OF CONTENTS
QUICK VIEW WIRING DIAGRAM..........................................................3-4
Connector Pin Configuration
Antenna Connector
Park Light Jumper
INSTALLATION NOTES............................................................................5
TACH LEARNING......................................................................................6
Tach/ Tachless Learn
Hybrid Mode
QUICK VIEW PROGRAMMING..............................................................7-9
Enter Program Mode
System Reset
Menu 1,2,3 & 4 Quick View
SYSTEM WIRING DETAILS................................................................10-14
Connector Views
Wiring Description
PROGRAM MENUS............................................................................15-23
Program Menu 1 Detailed
Program Menu 2 Detailed
Program Menu 3 Detailed
Program Menu 4 Detailed
SHOCK SENSOR (ALARM MODELS)....................................................15
Entering Adjustment Mode
TRANSMITTER PROGRAMMING...........................................................16
Adding/ Reprogramming Transmitter
DIAGNOSTICS.........................................................................................17
Diagnostic Chart
Diagnostic Memory
DOOR LOCK DIAGRAMS..................................................................18-19
Relay Diagrams
CONTACT INFORMATION.......................................................................20
SYSTEM PROGRAMMING -
Menu 1
PAGE 3
80 SERIES
INSTALL MANUAL
QUICK VIEW WIRE DIAGRAM
1
5
3
2
4
6
1
2
3
4
5
6
7
8
9
10
11
12
13
1
3
2
4
OUTPUT TO ACTIVATE
IGNITION CIRCUIT
THE
SELECTABLE OUTPUT* (DEFAULT 2ND IGN)
12VOLT/ 30 AMP MAIN POWER INPUT
OUTPUT TO ACTIVATE THE STARTER CIRCUIT
12VOLT/ 30 AMP MAIN POWER INPUT
OUTPUT TO ACTIVATE
ACCESSORY CIRCUIT
THE
SYSTEM GROUND INPUT
SELECTABLE PARK LIGHT OUTPUT (DEFAULT POSITIVE)
(-) HORN OUTPUT/ (+) SIREN OUTPUT (ALARM MODELS)
AUXILIARY 1 OUTPUT/ PROGRAMMABLE OUTPUT.
(-) 2ND ACCESSORY/ PROGRAMMABLE AUXILIARY 2 OUTPUT
AUXILIARY OUTPUT TO ACTIVATE TRUNK RELEASE
REARM OUTPUT (PULSE WITH LOCK & AFTER START)
NEGATIVE SECOND START OUTPUT
DISARM OUTPUT (PULSE WITH UNLOCK & BEFORE START)
POSITIVE DOOR INPUT (+ WHEN DOOR OPENED)
DIESEL WAIT TO START (+ or -) / TRIGGER TO START
TACH DETECTION INPUT (CONNECT TO COIL, INJECTOR...)
BRAKE SWITCH INPUT (12VOLT WHEN BRAKE IS PRESSED)
HOOD PIN SWITCH (GROUND WHEN HOOD IS OPENED)
PARK BRAKE INPUT (-) (”M” SERIES ONLY)
NEGATIVE DOOR INPUT (- WHEN DOOR OPENED)
Status Led’s
Program Button
* The selectable output can be changed in the program mode to output as a 2nd Accessory or 2nd Start output.
Default output is second ignition.
**This output does not change back to 2nd Ignition upon reset**
**(+) Siren output on alarm models and (-) horn honk output on starter models.
***A “M” series remote starter must be used when installing on a manual transmission vehicle.
NEVER
INSTALL AN AUTOMATIC REMOTE START IN A MANUAL VEHICLE!!
**** The door pin connection is used on Manual Transmission and Alarm Models Only.
DOOR PIN CONNECTION MUST BE CONNECTED FOR PASSIVE ARMING ON NON ALARM MODELS.
BLACK
WHITE
ORANGE
BROWN**
BLUE
WHITE*
RED
YELLOW
RED
GREEN
WHT/VIOLET
ORANGE/WHT
RED/WHITE
YELLOW
GRAY
BROWN
PURPLE****
BLUE
BLUE/WHITE
GRN/WHITE
GREEN****
PINK
BLK/WHT***
(-) STARTER KILL/ ANTI-GRIND OUTPUT
