Installation Guide
DIAGNOSTICS
12
If the alarm system is triggered while armed, the system will retain in memory the cause of the trigger. The
diagnostics can then be used to determine what the cause of the trigger was. When disarming the alarm,
the siren/horn will chirp 3 times instead of the usual 2 times to indicate the alarm had been triggered.
The system’s LED will also flash in pulses to indicate which input triggered the alarm.
NOTE
: LED status will be cleared when ignition is turned ON. For proper memory clearing, insure to
connect the ignition input to the
ignition
on the vehicle
Note:
While the system is disarmed and the ignition is in the off position, the LED will activate from the
following triggers.
1)
The door is opened. The LED will Stay on until the door is closed.
2)
The hood is opened. The LED will stay on until the hood is closed.
3)
The Shock Senor. The LED will flash when impact is detected.
4)
The Aux Sensor. The LED will flash when the input is triggered.
Alarm Diagnostics
Additional LED Flashes
Park Light Flashes
LED Flashes
Diagnostic
Two Flashes
Two Flashes
Shock Sensor Triggered
Three Flashes
Three Flashes
Door Input Triggered
Four Flashes
Four Flashes
Ignition Input Triggered
Five Flashes
Five Flashes
Hood Input Triggered
None
Off
System Disarmed
None
On Solid
Valet Mode
None
Single Flashes
System Armed
None
Rapid Flashes
Passive Arming