ACTIVE RF ANTENNA**
1 2
3
NOTE:
The jumpers control the output from the
WHITE
wire on the
main 6- pin harness. This is an
30amp relayed output
.
*The factory default setting of the Selectable Output jumper is position #3.
Output on White wire Jumper position
Second Starter Position 1
Second Accessory Position 2
Second Ignition Position 3
Status Leds
Program Button
**The antenna MUST be connected for the system to operate
*
The centre pin of the keyless entry harness is ONLY
available with plug-in devices such as the VP-1, DL-3,
DL-7 and Data Bus Modules.
Overloading this output will damage the remote starter.
1
2
Jumpers
Wiring Diagram
REMOTE VEHICLE STARTER
INSTALL MANUAL
PAGE 7
GREEN
RED*
BLUE
YELLOW
PINK
BLACK
Door Lock Output (-)250ma
12v Output (+)250ma (see notes below)*
Door Unlock Output (-)250ma
Negative Park Light/ Aux #6 Output (-)250ma
2nd Door Unlock/ Aux #5 Output (-)250ma
Horn Output (-)250ma
NOTE:
The 2 pin red connector on side N/A
1
2
3
4
1
2
(-) Input Trigger
Temperature Sensor (LT Series Only)
N/A
continued...
