Ultra Start 1270 series, Инструкция по установке

Страница: 12 / 28

INSTALL GUIDE
PAGE 12
IMPORTANT!
The system must be Tach Learned before remote starting.
1) Turn the ignition key to the “ON” position. The park lights will turn “ON”
2) Start the vehicle with the key. The LEDs on the antenna will turn on if a
proper tach signal is detected**, after 30-35 seconds the park lights will flash
and the siren will chirp twice to confirm Tach Learn.
NOTE: The LEDs will not turn “ON” for Auto Tachless Learn on the TL series.
* If the LEDs do not come “ON” during tach learn, a proper tach signal
was
not detected.
**If the park lights do not turn on check for proper connection on the BLUE
ignition wire at the 6-pin connector. This wire should be connected to the
vehicle main ignition wire and must not turn off during the start position.
If the ignition connection is correct, reset the system
(see System Reset page 14) and repeat step #1.
***
If the park lights do not flash in auto tach learn mode it may be
necessary to connect to a different tach source. It is important the
ignition output from the remote starter is connected to a wire that does
not turn off in the crank position. The remote starter will not tach learn
if connected to the wrong wire.
For best results connect the tach wire to the coil pack or to a fuel injector wire.
New - If the original Tach source is changed a system reset must be
preformed before a new tach signal can be learned to the system.
This does not apply if the Quick Learn feature is being used.
(See page 14 for System Reset).
Your Basic Install Is Complete!
NOTES:
1) If the vehicle does not start when the remote starter is activated, the
park lights will flash a diagnostic code. (See Diagnostic Chart page 28).
2) If the vehicle still does not start, check all connections and check for
factory Anti-Theft system.
Auto Tach/Tachless Learn