n
Insert the desired device and press
against the clamp
\
. This will give and
the device will simply be held by the
holder
^
. Now remove the pressure
from the clamp so that the device is
pressing against the holding tabs and is
therefore locked. Place the device so that
all side operating elements remain freely
accessible.
n
To remove the device, simply press it
against the clamp
\
again until it gives,
then remove the device at a slight angle.
The holder
^
can rotate through 360°
thanks to the ball joint
5a
, so the device
installed can be put in various positions
e.g. vertical (for instance for use as a
camera) or horizontal (for instance for
the satnav function). On the back of the
holder
^
there are two cable clips
·
with which a charging cable may be
attached (cable not supplied with the
holder).
Cable clips: narrow cable clip for cable
thicknesses of 2.4 - 3.0 mm wide cable
clip for cable thicknesses of 3.5 - 4.1mm
LB8_322267_1901_INT_Smartphonehalter_OSDE_OSNL_OSBE_OSCZ_OSGB_OSPL_OSSK_190607.indd 57
07.06.19 17:03
