Entering calibration mode
1. Open the Material Station door
3. Remove the power cable from the Material
Station and wait 5 seconds
5. Release the eject buttons
2. Push and hold the two right eject buttons
This starts the calibration of decoupler 2
2. Push and hold the two left eject buttons
This starts the calibration of decoupler 1
or
Note:
The Material Station can be powered on and connected to an
Ultimaker S5 when starting this procedure
Note:
For the next steps, keep holding the eject buttons until the
instructions specify to release them
4. Reconnect the power cable to the Material
Station and wait 5 seconds
Note:
The Material Station now enters calibration mode. The frame
LEDs will indicate the progess of the calibration procedure.
Note:
The Material Station will
flash once
.
