Ultimaker PVA Removal Station, Инструкция по установке и эксплуатации

Страница: 5 / 28

Ultimaker PVA Removal Station user manual 4
1.1 Safety messages
The information provided below is applicable to the PVA Removal Station (“Ultimaker product”).
This guide contains warnings and safety notices.
Provides additional information that is helpful to do a task or to avoid problems.
Warns of a situation that may cause material damage or injuries if the safety instructions are not followed.
The following ISO warning symbols are also used:
Magnetic field (ISO 7010-W006)
Electricity hazard (ISO 7010-W012)
Read the user manual (ISO 7010-M002). Before using this product, read the complete user manual to learn
about all its features and safety related information
1.2 General safety information
• The PVA Removal Station has moving parts that can cause injury. Never reach inside the Ultimaker PVA Removal
Station while it is in operation. Always control the PVA Removal Station with the user interface at the front.
• Do not change or adjust any parts of the PVA Removal Station unless the change or adjustment is authorized
by the manufacturer.
• Do not store items inside the PVA Removal Station.
• The PVA Removal Station is not intended for use by persons with reduced physical and/or mental capabilities,
or lack of experience and knowledge, unless they are supervised or have been given instructions concerning
the use of the appliance by a person responsible for their safety.
• Children should be under constant supervision when using the PVA Removal Station. Maintenance actions shall
only be performed by an adult.
1.3 Hazards
Electrical safety
The PVA Removal Station has been tested according to the IEC 62368-1. An easily accessible mains socket must
be used so that the product can quickly be unplugged when necessary. Be sure that the building installation
has dedicated means for over-current and short-circuiting. The PVA Removal Station is powered by mains
voltage, which is hazardous when touched.
Always unplug the product before performing maintenance. Modifications such as soldering of electronic
subunits are forbidden.
Never immerse the PVA Removal Station docking station in water or any other liquid.
Immediately unplug the PVA Removal Station if water comes into contact with the docking station.
Only use the original power cable supplied with the device. Do not damage, cut, or repair the cable. A damaged
cable should be immediately replaced with a new one.
Never use the PVA Removal Station if the power cable, docking station, container, or rotor is damaged.