Ultimaker PVA Removal Station, Инструкция по установке и эксплуатации

Страница: 16 / 28

Ultimaker PVA Removal Station user manual 15
4. Close the lids of the basket to fix the divider in place and lock the lids shut.
5. Lift the rinsing basket and lower it into the container.
6. Place the top cover onto the container.
Tip: Placement of the printed part can reduce dissolving time. Place and restrict the object, with the majority
of the PVA at the bottom, as far as possible in the lower corners of the rinsing basket. This is where the water
flow is most intense.
4.3 Select rotor speed
The PVA Removal Station is equipped with two rotor speed settings: Normal and Low. The Low speed mode is
recommended for smaller, fragile printed objects. Additionally, a Pause mode is available to allow intermediate
inspection of the part and dissolving process.
Note: The PVA Removal Station makes use of two rotational directions for optimal cleaning performance.
This will happen automatically. At the rotational direction change, the rotor will be stationary for several
seconds; this is normal.
1. Press the power button to power on the PVA Removal Station. The container illumination will start up. The
device powers on in Pause mode.
2. Press the rotor speed button once to activate Normal rotor speed. Both LED indicators will light up to
indicate full rotor speed.
3. To activate the Low rotor speed mode, press the rotor button again. Now, only the lower indicator will be lit,
indicating reduced rotor speed.
4. The PVA Removal Station is now set up, and the PVA dissolving process is active.
Note: Pressing the rotor button a third time will activate the Pause mode. Keep pressing the button to cycle
through the three different modes (Normal, Low, Pause) until you have reached the desired setting.