Ultimaker PVA Removal Station user manual
21
5. Lift the container from the docking station. Use either the handle at the top, or use the grips on either side at
the bottom of the container.
Dried-up PVA residue has highly adhesive properties. If any PVA residue came into contact with the docking
station, this could result in the container remaining attached to the docking station when the container is lifted.
Make sure the two parts are detached before walking away with the container.
6. Move the container to a water disposal location. Gently tilt the container and pour out the water using the
pouring spout at the back of the container.
Note:
PVA is a biodegradable material and can be disposed of down the drain, providing the wastewater
distribution network is connected to a wastewater treatment plant. Check local regulations for more
comprehensive guidance.
After disposal of the water, run hot water from the tap for approximately 30 seconds to remove any PVA
residue from the drain and avoid longer-term clogging issues.
7. Clean the container according to the maintenance instructions.
You can now refill the container for continued use or place it away in storage.
5.4 Storage
The Ultimaker PVA Removal Station must be stored according to the specified ambient conditions (see
section 2.2
).
Take the following actions to ensure the PVA Removal Station is stored safely and correctly:
1. Empty and clean the PVA Removal Station when the device is not in use.
2. Remove all saturated PVA with a moist towel and dry the docking station before placing the container on top.
3. Remove the rotor from the pin in the container and place the rotor in the rinsing basket. This prevents any
remaining PVA residue from gluing the rotor to the bottom of the container.
4. The rinsing basket can be placed back in the container.
5. Put the top cover on the PVA Removal Station.
Tip:
The PVA Removal Station can be placed back in its original packaging when placed in storage.
Содержание PVA Removal Station
