Ultimaker ORIGINAL+, Инструкция по сборке

Страница: 37 / 99

37
Left Y axle
To correctly place the left Y axle, perform the following actions:
1. Take one Y axle (long).
2. Rotate the wooden cap without hole (back panel, left).
3. Insert the Y axle through the back panel and move towards the front panel. Fig. 73.
4. Place the following parts on the left Y axle:
•
One timing pulley, with the thin side facing outwards. Place a long timing belt around this pulley. Fig. 74.
• The left sliding block. Make sure that the T-slot is facing inwards and the text is upright. Fig. 75.
• One timing pulley, with the thin side facing outwards. Place a long timing belt around this pulley. Fig. 76.
5. Move the left Y axle all the way into the front panel. Fig. 77.
6. Rotate the wooden cap without hole (back panel, left) back to its normal position and secure with a bolt M3x16 and
a hex nut. Fig. 78.
74 73
76 75
77 78