Ultimaker ORIGINAL+, Инструкция по сборке

Страница: 26 / 99

26
2. OTHER PARTS
1. Take wooden part 11A and attach it to the outside of the back panel. Use two M3x16 bolts and two lock nuts, place
the lock nuts on the outside of the frame. Fig. 36.
2. Take the two wooden parts 3B (4 mm) and place them on the top panel, over the holes.
3. Attach each wooden part 3B with two M3x16 bolts and two lock nuts. Fig. 37.
4. Take the metal cable clamp and attach it to the left panel using one M3x12 bolt and one lock nut. This clamp will be
used to keep the heated bed cable in place. Make sure to place the lock nut on the inside of the frame. Fig. 38.
Now that the frame is complete, run all the wires from the limit switches and the motors through the cable ducts and the
holes in the bottom panel.
Great, the frame is now ready!
37 36
38