UINICS SP-490 Series, Руководство по эксплуатации

Страница: 15 / 32

- 12 -
１０．Setting the mode
ａ．Calling up and modifying the mode setting
When a mode is set, operate each key according to the following table.
Operation key Indication Procedure
M ＋ . Ａ Ｂ Ｃ Ｄ
０ ０
Ｅ Ｆ Ｇ Ｈ
０ ２ ０ ０
While holding down the Mode key, press the
Shift key for 2 seconds or more.
“
00
”
appears in display CD and the value
setting for Mode 00 is shown.
M
Ａ Ｂ Ｃ Ｄ
０ ０
Ｅ Ｆ Ｇ Ｈ
１ ０ ０ ０
Changes the mode number.
Each time the key is pressed, the mode number
goes up by one.
（００→０１→・・・→１０→００→・・・）
. Ａ Ｂ Ｃ Ｄ
０ １
Ｅ Ｆ Ｇ Ｈ
１
０ ０ ０
→ → →
Shifts the flashing indication to the digit to the
right.
Each time the key is pressed, shifts the
indication to one right.
∧ Ａ Ｂ Ｃ Ｄ
０ １
Ｅ Ｆ Ｇ Ｈ
２ ０ ０ ０
Changes the value of the flashing digit.
Each time the key is pressed, the number goes
up by one.
（０→１→・・・→９→０→・・・）
RES After adjusting the setting, use this key to
register it. The display returns to the readings
following registration.
M ＋ . The display returns to the readings, without
registering.
When setting value has been changed by
mistake, use these keys.
Note：In case you change mode setting, turn off mode protect.（Refer to page 25）
If it is turned on, change of mode setting will be made impossible.