uhlmann & zacher CX8936, Инструкции по эксплуатации и монтажу

Страница: 14 / 18

CX8936 C
OMMISSIONING AND OPERATION
13
5.2 Configuring the online module
The configuration of the online mode normally takes place through the connected
third-party system and the corresponding function of the respective protocols.
Individual parameters of the online module can also be set directly via a BLE
connection or bus commands in the service mode.

Use a screwdriver or a similar tool to turn the rotary switch (6) so that the
arrowhead points to Position 4 (service mode). Then briefly press the button
(7) to switch to the service mode.

The active service mode is signaled by the green LED. In addition, the blue
LED flashes to signal BLE activity. In the case of an existing BLE connection
the blue LED lights up continuously.

Carry out the settings (e.g. LAN/WLAN communication) by means of the
associated software tool (details are available in the respective protocol de-
scription).

You can end the service mode at any time by again pressing the button (7) or
by changing the position of the rotary switch (6).
The program "Clex UZReader Test Tool (ClexUzRdrTT)" as of Version 2.8.6.2 can
be used to set up and test the connection via the Clex public UZ Reader protocol.
The parameters for the Wiegand connection can also be set with this tool. Con-
tact your Integration partner to purchase the software.
The "ClexSer OSDP Test Tool (ClexOsdpTT)" program can be used to set up and
test the OSDP connection. Contact your Integration partner to purchase the soft-
ware.
5.3 Operation
If an authorized transponder is held in front of the connected locking unit, a BLE
connection is established with the online module and, depending on the version,
the authorization is requested via the corresponding protocol of the third-party
system.
If no BLE connection can be established, for example in case of a power failure
or a wireless attack, the electronics of the locking unit drops back into offline
mode. In this mode the door can be opened with any transponder with offline
authorization.
In this case the electronics of the locking unit warns the user, however, before
opening with a distinctive visual and acoustic signaling.
When the locking unit is woken up, for example by a knob cylinder being turned
or a door handle or knob module being actuated, a wireless connection is also
established.
5.4 Resetting
Disconnect the device from the power supply.
Versions Clex public
protocol (phg_crypt)/
Version Wiegand
Version OSDP