uhlmann & zacher CX8936, Инструкции по эксплуатации и монтажу

Страница: 11 / 18

CX8936 I
NSTALLATION
10
4 Installation
4.1 General installation information

The valid national regulations for electronic installations
(e.g. VDE regulations) must be observed.

The connecting cables must be available and laid.

Only operate the device at the correct operating voltage.
 If possible, disconnect the load and operating circuits.

In the case of installation on metal surfaces or in direct proximity to metals,
the range as well as the communication between product and connected
locking units may be influenced negatively.

Avoid direct exposure to strong electromagnetic fields
 Do not paint over, paste over or cover the online module.
4.2 Installation
 Specify the mounting position. Ensure that the surface is smooth, dry and firm
enough. Do not place the units close to each other to avoid radio interfer-
ences.
 Mark the fastening points through the bottom of the housing
(No. 9 in layout diagram).

If required, drill mounting holes into the mounting surface.
 Insert the connection cables through the opening on the bottom into the
housing and cut and strip to a suitable length.
 Hand-tighten the lower part of the device at the intended location using suit-
able flat-head screws. Installation material is not included in the scope of de-
livery. In case of cable feeding from the side, use additional fitting rubber or
plastic spacers. Ensure that the cable is not pinched.
 Wire cables according to the respective pin assignment specified in the next
chapter. The two 8-pin connection blocks can be removed for easier installa-
tion.
 Perform commissioning (see the "Commissioning" chapter).
 Put on the housing cover and screw it tight.