15
warning in point 1 above.
4
Allow a minimum clearance of at least 15 cm all around the
dispenser so as not to impede the flow of cooling air.
5
Check the stability of the device, adjusting the height of the
feet if necessary. In the event that the dispenser is provided
with a series of high feet (approximately 100 mm), these must
replace the original ones.
6
The dispenser does not leave the factory pre-washed and
sanitised. Before use, it must be disassembled, washed and
sanitised, following the instructions in Chapter 7.4 CLEANING.
7
If required by local regulations, it is possible to have the
appliance permanently connected to electrical power supply,
ref. National Electrical Code (NEC) and NFPA 70. If this is the
case , remove the terminal block and, if necessary, enlarge the
hole on the sheet base, to allow the conduit entry.
6 TO OPERATE SAFELY
1
Do not
operate the dispenser without reading this
operator’s manual.
2
Do not
operate the dispenser unless it is properly
grounded.
3
Do not
operate the dispenser unless all panels are
restrained with screws.
4
Do not
put objects or fingers in panels louvers and faucet
outlet.
5
Do not
remove bowls, augers and panels for cleaning or
routine maintenance unless the dispenser is disconnected from
its power source.
6
This appliance is intended to be used in household and
similar applications.
7
The cover must be always closed.
7 OPERATING PROCEDURES
To remove the lid of the container, press the top key and slide
the lid towards the front of the container. If there is a safety lock
for the lid, turn the key in an anti-clockwise direction to release
the open key (see figure 6).
1
Wash and sanitise the dispenser before using it, following
the instructions in Chapter 7.4.3 WASHING.
2
Fill the container with the desired product, bearing in mind
that, during processing, the volume will increase. For this
reason, the containers must not be filled to maximum capacity.
To prepare granita, consider an increase in volume of around
10%.
3
If using liquid or powder bases, specially prepared for
granita, follow the manufacturer's instructions carefully.
4
If using natural products to prepare granita (for example
lemon juice, orange juice or coffee), dissolve 150-200 grams of
sugar in each litre of product.
5
If using freeze-dried bases to be diluted with milk or water,
prepare the product in a separate container and only pour it into
the mach ine con tain ers after making sure that i t is
homogeneous and that the powder is well dissolved.
6
Using the controls (see Chapter 7.1 DESCRIPTION OF
CONTROLS).
7
The dispenser must operate without interruption: the
cooling system for each container will automatically stop when
the product is ready to be dispensed, maintaining the set
density. The mixing devices will still continue to operate.
7. 1 DESCRIPTION OF CONTROLS
The dispenser is equipped with a main switch together with a
keyboard and a screen for each bowl. These devices allow
setting the dispenser operation mode. The following modes are
available:
STANDBY:
the dispenser is fed and it is ready to start.
GRANITA MAKING:
the dispenser makes granitas according to
the product in the bowl.
PRODUCT PRESERVATION:
the dispenser keeps the liquid
product at a suitable temperature for its preservation. This mode
can be usefully selected during the night, since it allows
maintaining the product quality while reducing energy
consumption.
WASHING:
only the mixers work, the cooling system is stopped.
This mode can be usefully selected during the dispenser
washing.
MAIN SWITCH
The main switch is located under the dispenser, on the left side.
It has the following functions:
CONTROL KEYBOARD
figure 1
ATTENTION
Make sure the device is properly earthed, otherwise you
may cause electric shocks to persons or damage to the
dispenser.
IMPORTANT
Place the device in such a way that the power cable is
easily accessible.
IMPORTANT
In any case, once the mixture is obtained, its degrees
Brix (sugar content percentage) must be greater than 13.
Never use the machine with water only.
IMPORTANT
Use the dispenser with food products only.
Position 0
: the dispenser is off.
Position I
: the dispenser can work but it is in Standby
mode. Only pilot light (A) is on.
