Ugin e.ON SINTER, Инструкция по эксплуатации

Страница: 33 / 87

Instructions for use (rev 05/18) e.ON SINTER
UGIN DENTAIRE
31
6.2. Control keys
Picture Keys Description
Start cycle
(RUN)
The selected program is started.
Pause
(PAUSE)
In running state, the program will be in a suspended
state, the temperature remains constant.
Stop
(STOP)
Under operating state or suspended state, the program
will end.
Ascent platform
(ARROW KEY
UPWARD)
Press this key, the platform will rise, press again, the
platform will stop at the desired level.
Descent platform
(ARROW KEY
DOWNWARD)
Press the key, the platform go down, press again, the
platform will stop at the desired level.
NOTE: if the furnace temperature is above 300°C, it is
not possible to start a cycle (risk of damages the
insulation materials).
Then, press descent platform key (ARROW KEY
DOWNWARD): an alert message appears in the status
bar (bottom of the screen)
Menu
(logo Microsoft)
Pull-down menu appears, as shown below:
Working interface Parameters current cycle display
Real-time curve Display of the cycle curve (temperature/time)
Program editor Program settings
Parameter setting
Software settings. Only access with technician code
(reserved for technicians customer’s service UGIN
DENTAIRE)
Language selection Available languages: English, French, Spanish and Italian
Date setting Setting the date, time and day of the week