UFO Vega, Руководство пользователя

Страница: 6 / 16

OPERATING THE ILLUMINATOR
-
VEGA CM
,
MCM
,
TM AND MTM MODELS ONLY
The Vega CM (color wheel) & Vega TM (twinkle wheel) have manual speed control on the
decorative motor. On these versions the light output is set to maximum and cannot be dimmed.
The Vega MCM & Vega MTM have manual speed control on the decorative motor and also
manual dimming control of the LED. The light output can be adjusted manually using the control
on the rear of the unit from no light output to maximum light output.
Under normal operation the decorative wheel motor speed can be adjusted manually using the
control on the rear of the unit. Motor speed can be adjusted from STOP to approximately 4 RPM.
OPERATING THE ILLUMINATOR
-
VEGA CDMX AND TDMX MODELS ONLY
To set the DMX address, switch off power to the illuminator and remove the top cover to access
the dip switch on the PCB as shown below. Set the address as detailed below and replace the
top cover. Connect up the illuminators with the PSU & remote DMX controller using the Mini XLR
sockets provided on the back of the illuminator - it doesn’t matter which socket is used.
SETTING THE DMX ADDRESS
DMX B
Start
Ch #
Dip
Switches
On
DMX B
Start
Ch #
Dip
Switches
On
1 1 11 1,2,4
2 2 12 3,4
3 1,2 13 1,3,4
4 3 14 2,3,4
5 1,3 15 1,2,3,4
6 2,3 16 5
7 1,2,3 : :
8 4 : :
9 1,4 : ;
10 2,4 511
1,2,3,4,5,
6,7,8,9
Switch 10 must be switched
off for DMX operation. Set the
DMX address using switches
1 - 9.
OPERATION
VEGA USER GUIDE
6