UFO Vega CM, Руководство пользователя

Страница: 12 / 16

ADDITIONAL PROCEDURES FOR DECORATIVE MANUAL MOTOR MODELS
Note:
please complete relevant troubleshooting procedures before returning the unit to us for
further investigation.
Problem Possible Cause(s) Remedy
Decora ti ve
wheel not
turning
Motor control at minimum Adjust motor control at rear
Dip switch no. 10 not switched
on
Remove cover and switch dip
switch no. 10 to on
Driver circuit or motor failure Contact UFO
Problem Possible Cause(s) Remedy
Not responding
to DMX control
Dip switch no. 10 is switched on
Remove cover and set dip switch no. 10
to o ff
DMX address not correctly set Remove cover and set correct address
No DMX signal from controller Check DMX controller for correct se tti ng
Wiring fault on DMX cables Check cables and repair as required
Driver circuit failure Contact UFO
ADDITIONAL PROCEDURES FOR DECORATIVE DMX MODELS
Problem Possible Cause(s) Remedy
No 0 ­ 10V signal
present
Dip switch no. 10 is switched
o ff
Remove cover and switch dip
switch no. 10 to on
No 0 ­ 10v signal at light source
due to cable or controller fault
Check input to light source using
a DMM set to correct range ­
rec ti fy cable / controller fault
ADDITIONAL PROCEDURES FOR DECORATIVE
0-10
V MODELS
TROUBLESHOOTING
VEGA USER GUIDE
12