UFO Vega CM, Руководство пользователя

Страница: 4 / 16

There are 3 connections required – the fibre port, the mains supply cable and the DMX control
cable. The fibre port should be connected first. Connect and secure the fibre optic connector
into the collar and secure using the M5 locking screw.
Connect the PSU to the DC input jack socket on the light source, and connect the IEC plug to the
PSU. Plug the mains plug into the electrical supply socket. Switch on power – the red LED
Indicator will illuminate and the light source is ready for use. If no light is produced consult the
TROUBLESHOOTING section of this user guide.
Connect the DMX control cable(s) to the Mini-XLR socket(s) on the rear of the light source. The
recommended plugs for these sockets are Multicomp SVP556-TA (female) or Multicomp SVP555-
TA (male). The pin out details for the plugs are shown below.
Either socket may be used as DMX in or DMX out.
CONNECTION
-
VEGA CDMX AND TDMX MODELS ONLY
Note:
UFO can supply converters for these light sources to allow them to be interfaced to
standard 3 pin XLR connectors or RJ45 connectors.
INSTALLATION
VEGA USER GUIDE
4