MicroLED Light Source Range
4
CONNECTION
There are 2 connections required – the fibre port and the mains supply. The fibre port should
be connected first. Connect and secure the fibre optic connector into the front of the unit
and secure using the M5 locking screw
Plug the mains plug into the electrical supply socket. Switch on power the led Indicator will
illuminate and the light source will start up automatically. If no light is produced consult the
TROUBLESHOOTING section
NOTE: THESE LIGHT SOURCES ARE NOT MAINS DIMMABLE.
MIC4000 REMOTE CONTROLLER
Specification:
Description
Details
Comments
Power
2 X AAA batteries
Range
30 metres
Measured in free space, may be attenuated by
obstructions or other RF devices
Frequency
2.4GHz
Approved for use in UK, Europe and USA
Batteries –
With The LED Light Source powered up as described above, remove the rear
cover on Remote Controller.
Taking care not to touch any of the front cover buttons,
insert the batteries. If you touch the remote control buttons when inserting the batteries it
WILL
effect the operation of your Remote Control. If you do accidentally touch any of the
buttons, remove the batteries and start again.Once the batteries are inserted do not use the
Remote Control for 3 seconds.
Test remote control functions as detailed on page 5. The Remote Controller is “matched” to
the Light Source at the factory. If the Remote Controller is not matched or an additional or
replacement Remote Controller is required (see NOTE 2) for the Light Source proceed to the
Matching Mode as follows. If a Remote Controller is to be removed from control of a Light
Source proceed to Unmatching Model on page 5
.
DO NOT TOUCH THE
BUTTONS WHILST
INSERTING
BATTERIES
