There are 3 connections required – the fiber port, the mains supply cable and the DMX control
cable. The fiber port should be connected first. Connect and secure the fiber optic connector
into the collar and secure using the M5 locking screw.
Connect the PSU to the DC input jack socket on the illuminator, and connect the IEC plug to the
PSU. Plug the mains plug into the electrical supply socket. Switch on power the led Indicator
will illuminate and the illuminator is ready for use. If no light is produced consult the
TROUBLESHOOTING section of this user guide.
Connect the DMX control cables to the Mini-XLR sockets on the rear of the illuminator. The
recommended plug for these sockets is Multicomp SVP556-TA. The pin out details for the plugs
are shown below. Either socket may be used as DMX in or DMX out.
It is recommended that a 120ohm terminating resistor be connected across DMX+ and DMX- on
the last illuminator in the DMX universe or cable run.
CONNECTION
-
LUNA
CDMX
AND
TDMX
MODELS
ONLY
Note:
UFO can supply converters for these illuminators to allow them to be interfaced to
standard 3 pin XLR connectors or RJ45 connectors.
INSTALLATION
LUNA
USER
GUIDE
4
Содержание Luna C 0-10V / UFO
Страница 15: ...NOTES 7 UFO LIGHTING...