UFO Cube DMX, Руководство пользователя

Страница: 3 / 16

POWER SUPPLY REQUIREMENTS
The Cube illuminator is powered from a
24V DC desk top power supply unit. This
PSU is an IEC input device catering for UK,
European and USA mains supplies using
the relevant power cord.
INSTALLATION
3
UFO LIGHTING
MOUNTING PLATE INSTALLATION
This luminaire supplied with a separate
mounting plate. If using the mounting
plate refer to the fitting instructions
supplied with it.
CONNECTIONS
There are 3 connections required – the fiber port, the mains supply cable and, optionally, the
DMX control cable. The fiber port should be connected first. Connect and secure the fiber optic
connector into the 30mm diameter collar and secure using the M5 locking screw.
Connect the PSU to the DC input jack socket on the illuminator, and connect the IEC plug to the
PSU. Plug the mains plug into the electrical supply socket. Switch on power. The LED Indicator
will illuminate and the illuminator is ready for use.
If no light is produced consult the troubleshooting section.
If DMX control is required, connect up
the DMX control cables to the XLR
sockets on the rear of the illuminator.
The pin out details for the plugs are
shown right.