UFESA Multihydro, Инструкции по использованию и установке

Страница: 8 / 32

8
EN
Safety information
This appliance is intended for domestic use
and the household environment only.
■ Install and operate the appliance as de-
scribed in the text and illustrations. We do
not accept liability for damage resulting
from failure to heed these instructions.
■ This appliance is intended for use up to an
altitude of 2000 m above sea level.
■ The appliance may only be installed and
stored in a frost-free room (due to residual
water).
Risk of electric shock!
Switch off the mains voltage supply
immediately if a fault occurs.
Immediately shut off the cold water
supply to the appliance should it leak.
■ The continuous-flow heater may only be
connected and put into operation by a
qualified professional.
■ In order to avoid potential sources of
danger, repairs and maintenance may
only be undertaken by a suitably quali-
fied specialist.
■ Never open the appliance without discon-
necting the power supply beforehand.
■ The statutory regulations of the respective
country, as well as those of the local electric-
ity and water suppliers, must be adhered to.
■ The continuous-flow heater is a Class I
appliance and must be connected to the
protective earth.
■ The appliance must be permanently
connected to installed pipes. The conduc-
tor cross-section must comply with the
installed appliance power.
■ Caution: Earthed water pipes may give the
appearance of a connected protective earth.
■ To guarantee compliance to relevant safety
regulations, an all-pole separator must
be fitted during installation. The contact
opening must be at least 3 mm.
■ The continuous-flow heater is only suitable
for closed (pressurised) operation.
■ The tap and outlet fittings must be ap-
proved for operation with closed (pressur-
ised) continuous-flow heater systems.
■ Only connect the continuous-flow heater
to a cold water line.
■ The continuous-flow heater is suitable for
connection to DVGW-tested plastic pipes.
■
Disconnect the electrical connection
cable from the supply and shut off the
water supply before connecting the
appliance!
■ Connect the water supply and then
connect the electrical supply.
■ Only make the openings which are re-
quired for installation on the rear of the
appliance. If the appliance is reinstalled,
the unused openings must be provided
with watertight sealing.
■ Do not touch electrically live parts after
installation.
■ The appliance should be disconnected
from the electrical mains supply when
working on the water supply. After service
work is complete, proceed as during the
first-time appliance start-up.
■ No changes may be made to the appliance.
■ The appliance may only be used for heat-
ing drinking water for household use.
■ This appliance can be used by children
aged 8 years and older as well as by per-
sons with diminished bodily, sensory or
mental perception, or those who lack
knowledge or experience, if they are moni-
tored or have received instruction concern-
ing use and comprehend the possible dan-
gers that can result. Children may not play
with the appliance. Cleaning and mainte-
nance by the user may not be performed
by unsupervised children.
■ Keep children away from the appliance.
■ Please monitor children to ensure that they
do not play with the appliance.
■ The mixer and the warm water pipe may
be hot. Please inform and instruct children
appropriately.
■ Do not use aggressive or abrasive cleaning
detergents!
■ Do not use a steam cleaner.
■ The appliance is only to be descaled by a
suitably qualified specialist.