UFESA CAPRI, Инструкция по эксплуатации

Страница: 25 / 58

19
Frothing milk / Making Cappuccino
You get a cup of cappuccino when you top up a cup of espresso with frothing milk.
Prepare espresso first with according to the
“MAKE ESPRESSO COFFEE” section.
Press the steam switch selector, the lamp in the coffee switch will be illuminated, wait until the indicator
in the steam switch selector is illuminated.
Note:
During operation, the indicator in the steam selector will cycle on and off to maintain to desired
temperature.
Fill a jug with about 100 ml of milk for each cappuccino to be prepared. You are recommended to use
whole milk at refrigerator or room temperature (not hot!).
Note:
it is recommended that the diameter of the jug is not less than 70±5mm, and bear in mind that the
milk increases in volume by 2 times, make sure the height of jug is enough.
Turn the steam control knob slowly anti−clockwise, steam will come out from frothing device.
Note:
Never turn the steam knob rapidly, as the steam will accumulate rapidly in short time which may
increase the potential of the risk of spillage.
When the frothing operation is finished, turn the steam knob to the min position.
Note:
Clean the frothing nozzle with a wet sponge immediately after steam stops generating, but care
not to hurt!
Pour the frothed milk into the espresso prepared. Now the cappuccino is ready. Sweeten to taste and if
desired, sprinkle the froth with a little cocoa powder.
Press the “on/off” button to switch the appliance off and turn the steam control knob to “o “ position.
Note:
we recommend to allow the coffee maker to cool down at least for 5 min before making coffee
again. Otherwise burnt odor may occur in your espresso coffee.
Producing hot water
With this function, you can pre−heat your coffee cup to ensure that the temperature of the coffee will not
decrease. So as to improve the coffee flavor.
Clean your coffee cup. After drinking coffee, you can directly make hot water with this coffee maker to
clean the cups. This makes it more simple and convenient to clean the cups.
When the preheating is finished, the coffee indicator lights up solidly. Then press the coffee switch, and
the water pump starts to pump water.
Turn the knob to “Hot water”, and then hot water will flow out of the steam pipe.
To stop making hot water, press the coffee switch again. Hot water is used for warming cup, making tea
or cooling down the appliance.
Please refer to the operation described in the section of “Make ESPRESSO” when need to adjust the
working time for making hot water.
Note: At first the hot water will scatter from the steam wand. May let the steam wand outlet close to the
coffee cup wall. Thus at this moment, you need to pay attention to the protection of hot water splash
burns skin.
Producing steam to heat liquids
Make sure that the control knob is at the “OFF” position.
Press the “on/off” button to switch the appliance on.
Wait until the heating light stop blinking.
Dip the wand into the liquid to be heated.
Turn the steam knob slowly anti−clockwise. Steam will come out from the wand.