UFESA AC2000, Инструкция по эксплуатации

Страница: 9 / 30

7
Pull the plug and cord (6) out of the vacuum cleaner.
While pulling out the cord, pay attention
to the yellow stripe which signals the
end of the cord. Further attempts (pulling
on cord) may result in damaging the cord.
8
Plug in the appliance.
Before operation make sure that the bag is installed in
the vacuum cleaner chamber and that inlet filter and
the outlet filter is installed in the appliance.
9
Switch on the vacuum cleaner by pressing the “on/
off” button (3) .
10
The vacuum cleaner is equipped with an electronic
suction power controller. The power adjustment is done
by means of a slider. By shirting the slider in a given
direction, you decrease or increase suction.
Filter disassembly
Before changing the filters make sure that the vacuum
cleaner is switched off and unplugged from the mains
supply.
INLET FILTER
1 Open the front cover handle (9) .
2
Pull the bag out of the chamber (see p.
E
).
3
Remove the inlet filter (11) out of the housing.
4 If the inlet filter (11) is dirty, it may be rinsed with
running water. Remember to dry the filter, before its
reinstallation.
Due to safety reasons, it is vital never to
install a damp inlet filter (11).
5
Install a new/the rinsed inlet filter (11) , making sure
that the whole filter is in the socket.
6
Insert a bag into the vacuum cleaner chamber
(see p. E ).
7
Close the front cover of the vacuum cleaner.
The damaged inlet filter should be
replaced with a new, genuine
manufactured product only.
C
OUTLET FILTER „MICROFILTER”
1 Press the lock and open the cap of the outlet filter,
then pull the cap out of the cleaner.
2
Take the used outlet filter out
(12)
.
● If the outlet filter (12) is dirty wash it in running water.
Remember to dry the filter before putting it into the
cleaner.
3
Put new/washed filter into the cleaner.
Due to safety precautions never put wet
outlet filter into the cleaner.
4
Put the cap so as to two ledges in the lower part of
the cap match the holes in the cleaner body, close the
cap by pressing it until you hear a characteristic “click”.
Damaged outlet filter should be always
replaced with a new original one.
Dust bag disassembly/assembly
Vacuum cleaner is equipped with SAFBAG bag (1 piece).
1
Total covering up of bag loading indicator by the
red cover in case the sucker or the brush is upraised
over the cleaned surface informs, that change of
dust bag is necessary. The bag loading indicator may
operate in case of suction hose stopping or in case of
stopping of equipment elements connected thereto.
2 Switch off the vacuum cleaner by pressing the on/
off button (3) .
3 Unplug the appliance.
4
Open the front cover handle (9) .
5
Press the side button on the end of the hose, then
remove the end of the hose from the inlet hole of the
vacuum cleaner.
6
Release the hook locking the bag holder according
to the arrow on the hook and then remove the bag with
the handle up.
7
Put out the bag plate from the holder. Dump the
filled bag into the garbage.
8
Caution! Do not throw the bag holder.into the trash.
9
Slide the plate of a new bag into the handle and
slide it until the end of the handle.
10 Insert the handle with the new bag into the seat of
casing and lock it with the locking hook.
D
E