DSD 700
OPERATING INSTRUCTIONS
7
6
On the TV, select any unused channel on which you wish to
view your satellite programmes (only in case of a non-SCART
or RCA connection). Once selected, all your satellite services
will be viewed on this channel, selection of the service being
made using the RCU.
7
Press and hold
UHF on the RCU for approx. 5 seconds until
UHF is displayed on the decoder display. Tune your TV set to
receive the decoder test signal display (see following figure).
A Channel number (initially 50) will be displayed on the
decoder front panel display.
Press UHF on the RCU to remove the test signal.
Check that any noise from the decoder does not interfere with
signals received on the VCR.
Check all tuned channels on the TV for interference.
8
If any interference is noticed, change the UHF channel number
as follows:
Press and hold UHF on the RCU to display UHF on the
decoder display and the UHF test screen on the TV.
Change the channel number by pressing and
on the
RCU.
Press OK to save. The following will happen as soon as
and
is pressed:
a. The TV display is lost because the TV is not tuned to the
new channel.
b. The new channel number is displayed on the front panel
of the decoder.
On the TV, retune the channel allocated to the decoder until
the decoder test pattern is clearly visible.
Repeat step 8 until interference on all channels is eliminated.
NOTE: After changes have been made, the decoder must
not be switched off for at least 3 minutes to allow for
the new setting to be saved.
If interference is still present, it is recommended that good
quality screened cables (preferably double screened) are used
for interconnecting all other equipments to the decoder.
Standby and Normal Modes
The decoder does not have a mains power on/off switch and it is
recommended that, for normal viewing, it remains connected to the
mains after installation. When the decoder is not in use, it should be
switched to the standby mode using the symbol on the front
panel or on the RCU.
The standby mode is indicated by a constant small green dot on the
right of the decoder display panel. To use the decoder after the initial
installation:
1
Switch on the TV and any other equipment included in the
system.
2
Select the channel on the TV that you have allocated for
viewing the satellite services (in case of a non-SCART / RCA
connection) or select the appropriate scart source (in case of
a SCART or RCA connection.
3
If the decoder is in the standby mode, press on the
RCU or decoder front panel, to return to the normal viewing
mode. A service number will be displayed on the front panel
indicator.
4
Press TV on the RCU. A Bouquet selection box is then
displayed on the TV screen . Select the bouquet you have
subscribed to, then press OK.
5
If you wish to select the Audio Services, press the key
on the RCU, or on the decoder front panel. If subscribed to,
an audio service will be heard, and the audio programme
information box will be displayed on the TV. A green indicator
on the front panel display is illuminated while the decoder is in
the Audio Services mode.
Some audio services are free-to-air and do not require a
subscription. TV Services are restored by pressing TV on the
RCU, or TV on the decoder front panel.
NOTE:
When switching from normal to standby then
back to normal, the decoder automatically returns
to the previously selected service.
If a SCART VCR is connected, it is not necessary
to take the decoder out of standby to view VCR
play back.
6
The decoder is set up to the local default settings by the
manufacturer. If it becomes necessary to change the
installation parameters consult your local installer.
The decoder is now ready for normal use.
UHF
Channel
50
UHF Frequency
703.25 MHz
Press OK to save
Press EXIT to cancel
Содержание DSD 700
Страница 32: ...32 OPERATING INSTRUCTIONS DSD 700 NOTES ...
