uebe VISOMAT COMFORT 2-, Инструкция по эксплуатации

Страница: 23 / 67

English English
EN-44 EN-45
Operating the device Operating the device
C C
Insert the batteries provided into the device.
If the device is to be operated using mains power, the cable con-
nector of the mains adapter (not supplied) must be plugged into
the socket on the right-hand side of the device. The batteries are
automatically switched off.
The device has a date/time function that can be activated as
required. This function is deactivated on delivery.
When the date/time function is activated, the measurement
results are saved along with their date and time. This can make
it easier to view the readings at a later point.
Press the Start/Stop button to activate the date/time function.
Then immediately press one of the two Memory buttons while
the full display is still visible. The function can be deactivated at
any time using the same procedure.
Initially, the display will show the four-digit year
number (Figure 1). Press Memory button 1 to
reduce the year number or Memory button 2 to
increase the year number. Confirm the entry by
pressing the Start/Stop button.
You are now able to set the month. (Figure 2).
Press Memory button 1 to reduce the value or
Memory button 2 to increase the value. Set the
correct month and confirm the entry by pressing
the Start/Stop button.
When the date/time function is activated, the device continues
to display the time even when it is switched off. The power con-
sumption for this is extremely low.
Activating and deactivating the date/time function
Setting the date/time
Please only use the visomat
®
mains adapter. See “Original spare
parts and accessories” on page 59.
• Remove the battery compartment cover on the underside of
the device.
• Remove the old batteries from the device and insert the
new ones. Please ensure correct polarity (marking in battery
compartment).
• Close the battery compartment by clipping the battery cover
back into the device.
When the “empty battery “ symbol first appears in the display,
you are still able to take around 30 measurements. Please re-
place the batteries within this time frame.
4. Initial operation of the device
6. Activating and setting the date/time
5. Inserting/replacing batteries
Figure 1
Figure 2
Repeat these steps to enter the day (Figure 2)
and the hours and the minutes (Figure 3).
After replacing the batteries, you will have to
reset the date and time.
To change the date and time, take the batteries
out and wait until the display goes off. Then you
can reset the date and time.
Figure 3
Changing the date/time