Udi Ultra 6, Инструкция по установке и обслуживанию

Страница: 10 / 16

1) Turn on the cold water supply and the under sink angle stop adapter but close the tank ball valve
( #09-9160 ).
2) Open RO faucet (
#70-5542
) (lower handle) for continuous flow.
3) Check system for leaks, tighten as necessary.
4) After 10-30 minutes, the water will start to drip out of the RO faucet. Let it drip for about 10 minutes and
then flip the handle to the closed position. TURN ON THE TANK BALL VALVE NOW . It will now take
several hours (2-3) for the storage tank to fill, depending on the local water pressure.
CAUTION: DO NOT DRINK THE WATER FROM THE FIRST TWO TANKS
PRODUCED BY YOUR NEWLY PURCHASED SYSTEM!
5) After the tank is full (you will hear the water stop), flush the system by placing the RO faucet handle in the
open position until the water is completely discharged.
6) Upon complete discharge of storage tank, turn handle to closed position on RO faucet and let the refilling
process begin. This process could take 2-3 hours to complete.
7) After the second tank is filled, repeat #6. Then enjoy your filtered water.
8) Check leaks daily for first week and periodically thereafter.
9) You may notice that the water may be milky colored during the first week. It is the air bubbles in the water.
It is normal and safe.
NOTE:
1) Do not use with water that is microbiologically unsafe or of unknown quality without adequate disinfection
before or after the system. Systems certified for cyst reduction may be used on disinfected water that may
contain filterable cysts.
2) This reverse osmosis system contains a replaceable component critical to the efficiency of the system.
Replacement of the reverse osmosis component should be with one of identical specifications, as defined by
the manufacturer, to assure the same efficiency and contaminant reduction performance.
WARNING: Do not use this RO system appliance to purify non-drinkable sources of water that
are unsafe or with water of unknown quality.
WARNING: Never use hot water or freeze unit.
WARNING: Incorrect installation will VOID the warranty.
STEP 5: SYSTEM START UP
NOTE:
9