��
OPERATION
� Install the optical fiber on cutter as shown in the figure
below and check optical fiber’s state and cutting length.
� When optical fiber is not properly installed, problems
may be incurred on cutting procedure.
� Pull down and press the cover to cleave the fiber.
Lift the cutting lever and take the optical fiber out.
� Remove the fiber fragments and dispose it in
a proper container.
� Open the windshield cover and optical fiber.
� Put optical fiber between V-Groove and electrode.
Be careful not to make the tip of prepared optical fiber
bump against other objects.
� Fix the optical fiber with hands to prevent its move and
close the clamp with care.
� Install the optical fiber on the opposite side in the same way.
� Close the windbreak cover with care.
Please read user manual of the cleaver for more
detailed information about the operation of the cleaver.
The better the optical fiber is installed at a proper location,
the shorter it takes for alignment.
CLEAVING
THE FIBER
LOAD THE FIBER
TO SWIFT K��A
