UBTECH Sensor-controlled safety sign USER MANUAL
UBTECH ROBOTICS CORP LTD
meters, which can block a conventional room door (such as hotel or hospital room
door)
•
Users can upgrade firmware via Bluetooth OTA
•
Pairing steps of Sensor-controlled safety sign:
When it is not paired, it will prompt "there is no pairing Sensor-controlled safety
sign"
Find the Bluetooth device and list the devices that can be found after searching
for a period of time
Note
: the Bluetooth MAC address is pasted on the body of the caution for user
identification. At the same time, the interface prompts the user that "the Sensor-controlled
safety sign should open the pairing mode".
Start pairing and select any Sensor-controlled safety sign. If it is successful, it
will prompt "the selected Sensor-controlled safety sign are paired successfully!"
Otherwise, it will prompt "matching of the selected Sensor-controlled safety sign
failed!"
If the pairing is successful, the information of the paired Sensor-controlled safety
sign will be displayed. At the same time, the paired disinfection devices
broadcast voice
Continue to add Sensor-controlled safety sign, up to 4 at present. Or you can
cancel the pairing with the Sensor-controlled safety sign
Part 5 Transporting, Clean and Storage
5.1 Transportation
If you need to transport ADIBOT, please put it in the box.
5.2 Maintenance
Warning:
Do not use abrasives, aerosols, alcohol containing liquids or other liquids to clean
the Sensor-controlled safety sign, because they may contain flammable substances or
may damage the plastic shell, cloth and printed characters on the cloth. Do not spray or
spray the Sensor-controlled safety sign with water or other liquids. Please keep the
Sensor-controlled safety sign dry.
Follow the steps below to ensure safety and avoid damaging the Sensor-controlled
safety sign:
1. Press the power button on the side of the main control box to close the caution
sign;
2. Open the back cover of the main control box and take out the battery to ensure
that the access plate is completely powered off;
3. Clean the outside of the Sensor-controlled safety sign with a soft damp cloth;
4. Wipe the outside of the Sensor-controlled safety sign thoroughly with a soft dry
cloth;
5. Check whether the Sensor-controlled safety sign is dry.
Note: take out the battery when the Sensor-controlled safety sign is not used for a