WWDZWx User Manual
Date:9-Jun-2021
Ubitech Ltd.
Version:0.3
15
12.4 Factory Default Reset
-
End-user can perform Factory Default Reset when you met below things and it will involve gateway in
Exclusion / Remove device operation,
i.
The WWD lost connection permanent or no longer be paired with Z-Wave Network or controller;
ii.
Re-include WWD with other Z-Wave Network without perform exclusion with previous Z-Wave Network;
iii.
To exclude the WWD from Z-Wave Network and then re-include into Z-Wave Network.
-
Please note that once WWD performed Factory Default Reset, all setting will be restored to Factory Default as below.
i.
Remove the WWD from Z-Wave Network and reset the node ID,
ii.
Restore Association Group to default,
iii.
Restore the configuration settings to the default.
-
To perform Factory Default Reset as following steps – Only works in Mesh Network Mode
i.
Shaking Custos WWD in Vertical / Horizontal to wake up it until get 1x Buzzer Sound & 1x GREEN LED ON;
ii.
Then stop shaking it, leave WWD on the table in Horizontal position as Figure 12C;
iii.
Wait for Position Recognition confirmation UI with Buzzer Sounds & GREEN LED flashing 2 times “Event success UI”;
iv.
While GREEN & RED LED are flashing alternative for Gesture Recognition then roll Custos WWD in one complete turn
“360°”and stick close to table surface as Figure 12D;
v.
Wait for Gesture Recognition configuration UI with Buzzer Sounds & GREEN LED flashing 2 times “Event success UI”;
vi.
Then WWD will perform soft reset after GREEN LED is flashing for 2 seconds;
vii.
After soft reset with RED LED & Buzzer Sound x1 to finished Factory Default Reset action then SmartStart also will be
activated.
Roll
360°
Figure 12D
Figure 12C
