11
www.ubisys.de
u
200 (0xC8) Private
Private. This endpoint contains a legacy private application and is provided
for backwards-compatibility, only. This feature is deprecated and will be
removed in a future firmware release after a grace period.
232 (0xE8) 0x0104: Common Profile (HA)
Device Management (0x0502)
11
242 (0xF2) 0xA1E0: Green Power Profile
ZigBee Green Power Combined Proxy and Sink
12
The ubisys ZigBee manufacturer ID is 0x10F2. This manufacturer code is used to identify OTA upgrade
images, for accessing manufacturer-specific ZCL attributes and commands etc.
Installation Code
This power switch has a pre-configured link key, which is derived from the installation code printed on
the back of the unit’s housing in text format and as a two-dimensional barcode (QR code). The format
specified in [R6], section 5.4.8.1.1 is used with a full 128-bit installation code + 16-bit CRC. The QR
code contains additional information as illustrated in the following example:
ubisys2/R0/001FEE00000000FF/0F7C1CD805F91649EBA84580AA1CB432F51A/21
Here, “ubisys2” is the data format identifier, R0 is the model string (this is just an example, it would be
“S2” or “S2-R” for this product), followed by the EUI-64, the installation code, and a checksum that
covers the entire information (including model, EUI-64 and installation code), all separated by a single
dash character (‘/’). The check sum is an unsigned 8-bit integer, which is calculated by performing a
byte-wise exclusive-or (XOR, “
”) of the ASCII characters of the model string, the binary
representation of the EUI-64 (in big endian format), and the binary representation of the install code.
For the example above, this calculation yields:
52 (‘R’)
30 (‘0’)
00
1F
EE
00
00
00
00
FF
0F
7C
1C
D8
05
F9
16
49
EB
A8
45
80
AA
1C
B4
32
F5
1A =
21
Notice: The data format “ubisys1” is identical to “ubisys2” except for the check sum, which is present,
but invalid. If you encounter “ubisys1” labels, then do not verify the trailing check sum field.
11
Since application version 1.02 (S2), or 1.01 (S2-R), respectively. Prior, device ID 0x0008 (Range Extender)
was used.
12
Since application version 1.06.
