18
www.ubisys.de
u
7.3.
Application Endpoint #2 (S1/S1-R) – Primary Level Control Switch
This is a Finding & Binding initiator endpoint.
7.3.1.
Basic Cluster (Server)
Please refer to section 7.7.1 for details.
7.3.2.
Identify Cluster (Server)
Notice: The identify cluster instance on this endpoint does not provide any visual or audible feedback. It
is mainly present to comply with standards requirements.
Attributes supported:
Attribute
Type
Description
0x0000
unsigned16
IdentifyTime
The remaining time, in seconds, the device will be identifying itself.
Notice that S1 currently does not provide any visual feedback in identify mode.
Cluster commands supported:
Command
Description
0x00
Identify
Puts the device into identify mode, or terminates identify mode.
0x01
Query Identify
Determines whether the device is currently identifying, and returns the remaining time if so.
7.3.3.
Scenes Cluster (Client)
This cluster is available on devices running firmware version 1.04 and above.
Notice: This cluster does not use the binding table for managing command targets. Instead, recall
scene command templates include the group address and scene number to recall. The device setup
cluster on the Device Management endpoint can be used to configure the behavior of the cluster, i.e.
which identifiers will be sent in the message body, when the input state changes. Using the device
setup cluster, you can configure this endpoint either to be used with a push-button or a switch.
This cluster instance is intended for recalling scenes on the local and/or remote devices using the local
inputs and is not bound when factory fresh.
Cluster commands transmitted:
Command
Description
0x05
Recall Scene
Recalls a scene. The group address in the recall scene command payload is also used as the target for the
command.
