UBI EasyCoder 201 II E
UBI EasyPak 501 E – Getting Started
5
230V
0
MADE IN SWEDEN
Type
Art. No.
Ser. No.
115/230 V 2.6/1.3 A 50–60 Hz
TA
Voltage Switch
Power Switch
Power Cord
Receptacle
Serial Interface Connectors (RS232)
Parallel Interface Connectors
(Centronics)
230V
0
MADE IN SWEDEN
Type
Art. No.
Ser. No.
115/230 V 2.6/1.3 A 50–60 Hz
TA
CONNECT POWER CORD
❏
Turn the printer OFF!
❏
Make sure that the power switch on the upper back of
the printer is turned OFF (so that the 0 side of the
switch is pressed down).
❏
Connect the power cord into the receptacle on the
back of the printer. Plug the other end of the power
cord into an AC power outlet.
(N.B. Check that the printer is set for correct voltage,
115 V or 230 V.)
CONNECT INTERFACE CABLES
❏
Before connecting an interface cable, please make
sure that both computer and printer are turned OFF.
❏
UBI LabelShop
– use serial interface cable
Connect the serial interface cable to the connector on
the back of the printer and fasten the cable with the
screws attached to the cable connector. Connect the
other end of the serial interface cable to the PC serial
interface in the same way.
❏
Other
Windows
programs – use
parallel
interface
cable
Connect the parallel interface cable to the connector
on the back of the printer and secure it with the clips
attached to the cable connector. Connect the other
end of the parallel interface cable to the PC parallel
interface and fasten the cable with the screws at-
tached to the cable connector.
❏
Turn the printer ON!
