Uberhaus 1861, Руководство оператора

Страница: 4 / 11

4
Operation
1. Connect the appliance to the power outlet.
2. The appliance emits a beep and the power indicator light (G) comes on and remains on as long
as the appliance is powered.
3. The appliance goes into OFF. If the display shows a blinking dot, it means that the tip over switch
has been activated.
4. Press the ON/OFF button (A) to turn on the appliance. It will begin to heat with the predefined
settings.
5. Press the MODE button (E) to select one of the following functions available: Heating 1
（ ）
Heating 2
（ ）
Heating 3
（ ）
ECO Ventilation ( ) Anti-freeze ( ).
5.1 Ventilation ( ) In this operating mode only the fan operates, so the appliance does not heat
the room.
5.2 Anti-freeze ( ) In this operating mode the appliance keeps the room at a temperature of
45°F (7°C) to prevent freezing temperatures.
5.3 Heating 1, Heating 2 and Heating 3
Heating 1 (600W):
The appliance operates at the minimum power, reducing noise and energy consumption to the
minimum.
Heating 2 (900W)
The appliance operates at the middle power for rapid heating of the room.
Heating 3/BOOST function (1500W):
The appliance operates at the maximum power for rapid heating of the room.
5.4 ECO function: in this operating mode the appliance can be set to automatically adjust the
temperature of high, medium and low operation mode, the highest temperature is up to 32°C.
When the ambient temperature is below the high set temperature by 1 to 4 degrees, the heater
will operate in low mid-range cycle. When the ambient temperature is below the high set
temperature by 4 degrees or more, heater will be running at maximum power.
6 If you want the appliance to distribute the airflow over a larger area, press the oscillation button
(C)( ).The appliance will then oscillate right and left. To stop the oscillation in the desired
position, just press oscillation button (C) again.
7 To turn off the appliance press button ON /OFF (A). The display will show a countdown for about 6
seconds.
NOTE: The display can show the temperature in both °F and °C.
To change the temperature scale, press and hold the + key for a few seconds, then release.
THERMOSTAT INSTRUCTIONS
1. Press the MODE button (E) until the Mode indicator lights in ECO mode.
2. To adjust set temperature, Press the button + to increase the desired temperature and the button -
to decrease the desired temperature.
3. When the air temperature reaches 2 degrees above the set temperature, the heater will stop to
heat at once and stop to blow after 15 seconds.
4. When the air temperature drops 2 degree below the set temperature, the unit will come back on.