Control
switch
LCD display
Steering
lock
Kill
switch
Throttle
Rear brake
Front brake
12
13
Turning off
Security Mode
will allow
anyone with access to the bike to turn it
on and use it.
5. HANDLEBAR CONTROLS
5.1 Control Switch
On the left side of the handlebar you will find a
control switch with buttons for the headlight,
indicators, & horn.
The headlight and tail lights automatically come on
when the 2✗2 is in Drive. To turn off the headlight,
either switch to Neutral using the key fob or kill
switch, open settings in the UBCO Rider's App and
turn lights off, or hold the low beam switch until it
turns off (repeat to turn back on).
Holding the high beam switch will activate the
headlight in Neutral for when temporary lighting is
required while the throttle is inactive. Do not use the
high beam against oncoming traffic.
5.2 Kill Switch
On the right side of the handlebar, next to the
throttle, is the kill switch for the motors. When the
kill switch is activated, the bike will change to Neutral
and N shows on the LCD display.
To switch into Drive, retract the kickstand and press
the kill switch to deactivate it.
5.3 Security Mode
Security Mode determines whether the key fob is
required to turn the bike on.
Security Mode ON:
The key fob is required to turn the
bike on.
Security Mode OFF:
Enables the bike to be powered
without the key fob; the bike is turned on using the
kill switch.
To turn security mode on or off, follow the steps
below. (Note, this process can only be performed
using a fob that is already paired to the bike.)
1.
Turn off the bike. Press and hold both the key fob
button and the kill switch for 10 seconds.
2.
The bike will beep a few times while the buttons
are held and then give one final long beep to
indicate programming is complete.
5.4 Phone Mount
The bike comes fitted with a Peak Design phone
mount featuring vibration isolation to protect your
phone and magnetic locking technology to enable
one-handed phone attachment and removal.
Simply attach the Universal Adapter to your phone
case following the instructions provided or use a
compatible Peak Design phone case. Then, to attach
your phone, simply hold the back of your phone over
the mount and it will click into place. Press one of the
tabs on either side to release your phone.
