U.S. Products SPOTTER, Руководство по эксплуатации

Страница: 5 / 12

SET-UP:
1. Open the Latches (6) and remove the Vacuum Tank (4) from the machine.
2. Fill the Solution Tanks (1 & 2) -- one tank will hold your diluted cleaning chemical and the second tank will hold clean water.
3. Place the Vacuum Tank (4) back onto the base, and secure the Latches (6) . Make sure the Screw-in Access Lid (7) is in place and tight.
4. Attach the Vacuum Hose (8) to the Vacuum Inlet (5) on the Vacuum Tank (4) .
5. Connect the Solution Line (9) to the Quick Coupling (10) on the front of the spotter base.
6. Attach the Cleaning Tool (11) to the other end of the Vacuum Hose (8) and Solution Line (9) ..
7. Turn the knob on the Solution Valve (3) to the desired tank.
8. Turn the Rocker Switch (12) on. This will start the pump and the vacuum.
9. Press the lever on the tool to begin spraying.
NOTE: It may take a few seconds for the solution to reach the spray tip. The tool will automatically suck up the sprayed solution as the tool passes over the
wet area.
NOTE: When switching from one tank to the other tank, it may take a few seconds of spraying for the solution in the selected tank to reach the spray tip.
10. When fi nished with the job, disconnect the hoses from the Spotter, remove and empty the Recovery Tank (4) , then dump the water out of the Solution Tanks
(1 & 2) and clean them.
revised 2/12
1
2
3
4
5
6
7
8
9
10
11
12
1/10 A - 5 56041856 - SPOTTER
ENGLISH - A INSTRUCTIONS FOR USE
https://harrissupplyind.com - To Order Parts Call 608-268-8080